CTC Union EcoZenith i360 Series Installation And Maintenance Manual page 119

12.12.4 Settings coded
This menu is intended to set the manufacturer's
operational and alarm limits. A 4-digit code must be
specified to be able to amend these limits. However,
you can also look without any code to see what options
feature in the menu.
12.12.5 Quick start compressor
The delay normally prevents compressor start earlier
than 10 mins after compressor stop. The delay is also
activated in the event of a power failure, or the first time
after production is started. This function speeds up this
process.
12.12.6 Software update
The display software can be updated either via USB
drive or online. The rows are greyed out until the USB
drive is installed or the display is connected to the
internet.
Click OK to confirm the upload.
The settings are retained during updating, but the old
values are overwritten by any new factory values.
12.12.7 Write log to USB
Intended for service engineers. This function can be
used to save logged values to a USB memory stick.
12.12.8 Re-installation
This command relaunches the installation sequence.
First, confirm that you want to reinstall to access the
installation wizard, refer to the "Installation Guide" and
"First Start" chapters.
!
NB: Only an authorised service engineer is allowed to log in to the Factory settings
coded option. Severe operational problems and faults may occur affecting the
product if values are amended without authorisation. Note that in such cases the
warranty terms do not apply.
Menu: "Installer/Service/Coded settings".
Menu: "Installer/Service/ Software Update".
!
NB: The power to the product
must not be interrupted, under any
circumstances, during the update
process.
119
CTC EcoZenith i360