Maintenance And Troubleshooting - Weslo 831.283160 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
cycle regularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, refer
to assembly step 8 on page 7 and remove the con-
sole from the handlebar. Next, insert three batteries
into the console. Reattach the console to the handle-
bar, being careful not to pinch the console wire.
HOW TO ADJUST THE RESISTANCE STRAP
If the resistance knob is turned to the highest setting
and there is not enough resistance, the resistance
strap may need to be adjusted. To adjust the resis-
tance strap, you must first remove the left side shield.
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it. Next, remove the five M4 x
25mm Screws (41) and the M4 x 16mm Screw (49)
from the Left Side Shield (17). Carefully remove the
Left Side Shield.
41
17
49 24
41
Next, turn the resistance knob to the lowest setting
(see HOW TO ADJUST THE PEDALING RESIS-
TANCE on page 8).
Open the Strap Clamp (3) and pull the end of the
Resistance Strap (11) downward slightly to increase
resistance. Close the Strap Clamp and turn the
Flywheel (37) to make sure there is not too much
resistance.
11
3
37
When the resistance strap is properly adjusted, re-
attach the left side shield and the left pedal.
10