Advertisement
Trada 2-leg
Assembly
Step #7: screw side brackets to worksurface
• Align the rear of the feet with the rear edge of the table
• Double-check that the frame is centered side-to-side.
• Screw the side brackets to the table using two #10x1" wood screws per bracket.
align rear of foot
with rear of table
#10x1"
Phillips pan head
Step #8: screw crossbars to worksurface
• Screw the crossbars to the table using from two to five #10x2½" wood screws per crossbar.
— Use all available crossbar-to-worksurface holes. The number of these holes depends on how much the
crossbars were expanded in step #5. In the example below, two screws per crossbar are used.
#10x2½"
Phillips pan head
Page 7
Advertisement
