Related Manuals for ESI Enmo 2NM-C48-SLV
Summary of Contents for ESI Enmo 2NM-C48-SLV
- Page 1 Enmo ™ Assembly and operation instructions Electric height adjustable table base Model# 2NM-C48-SLV Model# 2NM-C48-BLK Model# 2NM-C48-WHT...
-
Page 2: Table Of Contents
Enmo Components and tools Caution • Hand tighten all hex-head screws. Use power drill on self-tapping screws only. table thickness • Always check that screws used to attach components to the worksurface are not too long for the thickness of the table. Please review these instructions before beginning the installation. -
Page 3: 4Mm Allen Key
Enmo Assembly Step #1: adjust frame width • Place the worksurface facing down on a soft, clean surface. • Center the frame front to back on the worksurface. • Adjust the width of the frame. 4mm Allen key — Use the 4mm Allen key to loosen all eight pre-installed M6x10 screws in the cross channels. -
Page 4: Top Supports
Enmo Assembly Step #3: attach feet • Attach a foot to each leg with four M6x14 screws per foot. 4mm Allen key M6x14 Step #4: attach top supports • Turn the frame upright. • Attach the top supports to the end of the frame with two M6x12 screws per support. support 4mm Allen key M6x12... - Page 5 Enmo Assembly Step #5: install rubber cushions and plastic pads • Insert rubber cushions into the holes on the ends of the top supports and center of the two crossbeams. — When properly inserted, the cushions will be centered vertically. •...
-
Page 6: St4.8X25
Enmo Assembly Step #6: secure frame to worksurface • Turn the assembly over and place the frame and top supports onto the worksurface. — Center the assembly on the worksurface, front to back and side to side. • Using a power drill and #2 Phillips bit, secure the frame to the worksurface with six ST4.8x25 self-tapping screws. —... -
Page 7: St4.8X19
Enmo Assembly Step #7: if optional caster kit was ordered, install casters stem nut • Remove the two glides attached to each foot. screw in caster unscrew glide — Unscrew the glides to remove them. • Attach two casters to each foot. —... - Page 8 Enmo Assembly Step #9: connect cables and cords • Connect the cables from the handset and each of the leg motors to their ports on the control unit. • Plug the female end of the power cord into the control unit. •...
- Page 9 — Re-initialize the table. Be sure to press both buttons until you hear the beep sound. Be sure the table moves to its lowest position and then “bumps up” slightly. — If problems continue, call ESI Customer Service at 800.833.3746.
- Page 10 Enmo Troubleshooting Troubleshooting Guide Problem Possible Cause Solution The table stops suddenly during Overuse — operation of the table Wait 20 minutes to resume normal use. After 20 minutes, the control unit will operation and the control unit beeps has exceeded the duty cycle reset and operation can continue.
- Page 12 LIMITED WARRANTY ESI warrants this product to be free from defects in manufacturing for a period of 15 years on structural parts and 7 years on electrical parts from the date of original purchase. This warranty extends only to the original purchaser, and does not apply if the product has been damaged or fails to function properly as a result of misuse, abuse, modification, alteration, or improper cleaning or maintenance.