ESI TRIUMPH 2T-C28-24 Assembly Manual

ASSEMBLY GUIDE
1. ATTACH (I) FOOT PLATES AND (D) FEET TO BOTH (A&B) LEG
COLUMNS USING (N) M6X35 SCREWS (X8) BE SURE THE LONGER
SIDE OF THE FOOT GOES TOWARDS THE FRONT OF THE TABLE.
2. SET (B) LEG WITHOUT MOTOR UPRIGHT AND MANUALLY PUSH
DOWN TO THE LOWEST POSITION.
3. SET (A) LEG WITH MOTOR UPRIGHT.
4. ATTACH (F) CROSS CHANNEL TO THE (A&B) LEG COLUMNS USING
(M) M6X8 SCREWS (X4).
5. ATTACH THE (C) TOP SUPPORTS TO THE LEG COLUMNS USING
(O) M8 SCREWS (X4).
6. ATTACH THE (D) CROSS CHANNELS TO APPROPRIATE LENGTH AND TIGHTEN SECURELY
USING THE (L) M10 SCREWS (X4).
7. CONNECT THE 2 LEGS WITH THE CONNECT BAR (PULL THE CONNECT BAR TO THE
APPROPRIATE LENGTH).
8. ATTACH WORKSURFACE USING APPROPRIATE LENGTH SELF-TAPPING SCREWS. BE SURE
SCREWS ARE CORRECT LENGTH SO AS NOT TO PIERCE TOP OF WORKSURFACE.
9. ATTACH (J) KEYPAD/SWITCH AND (G) CONTROL UNIT UNDER WORKSURFACE IN
PREFERRED LOCATIONS.
10. ATTACH (H) LEG CABLE TO LEG WITH MOTOR ONLY.
11. CONNECT (J) KEYPAD SWITCH TO CONTROL UNIT. PLUG IN CONTROL UNIT TO POWER
SOURCE AND MOVE LEG DOWN TO THE LOWEST POSITION USING THE KEYPAD SWITCH.
12. TIGHTEN ALL SCREWS SECURELY.
13. MANAGE CABLES APPROPRIATELY AND IF NECESSARY, ADJUST LEVELING GLIDES ON
TABLE FEET TO LEVEL THE WORKSURFACE.
14. INITIALIZE LEGS: AFTER TABLE BASE IS FULLY ASSEMBLED AND
POWER CORD HAS BEEN PLUGGED IN, HOLD DOWN BOTH UP AND
DOWN BUTTONS ON KEYPAD/SWITCH FOR 5-10 SECONDS OR UNTIL
BOTH LEGS ARE IN THE LOWEST POSITION.
ZERO-SET BEFORE USE!
TRIUMPH ELECTRIC - 2-LEG
TABLE BASE MUST BE
ASSEMBLY GUIDE
1
7
TRIUMPH ELECTRIC - 2-LEG
6
8