Related Manuals for ESI ALL-FLEX FLEX3-SLV-V1
Summary of Contents for ESI ALL-FLEX FLEX3-SLV-V1
- Page 1 ALL-FLEX ™ Model FLEX3-SLV-V1 Model FLEX3-BLK-V1 Model FLEX3-WHT-V1 3 LEG ELECTRIC TABLE BASE FLEX3-V1 Rev B 6/17 ASSEMBLY AND OPERATION...
- Page 2 ALL-FLEX 3 LEG ELECTRIC TABLE BASE PARTS AND TOOLS ™ PLEASE REVIEW these instructions before beginning the assembly procedures. Check that all the parts shown below were provided with your order. Contact your supplier if any materials are missing. Do not discard the your satisfaction.
- Page 3 ASSEMBLY ALL-FLEX 3 LEG ELECTRIC TABLE BASE ™ STEP 1 With the work surface facing down on a soft, clean surface, arrange the leg columns and center leg top supports as shown. • Unfold the hinged side legs and place them motor-side down at the ends of the work surface. •...
- Page 4 ALL-FLEX 3 LEG ELECTRIC TABLE BASE ASSEMBLY ™ STEP 3 Route the side column motor cables under the notch on the angled portion of each frame. Route Cable Under Notch STEP 4 Install the cross channels. • Insert each cross channel into the frame and center leg top support. —...
- Page 5 ASSEMBLY ALL-FLEX 3 LEG ELECTRIC TABLE BASE ™ STEP 6 Attach the two-piece side top supports. One piece is attached to the frame; the other piece is separate. • Insert the separate piece of the top support into the top support attached to the frame. •...
- Page 6 ALL-FLEX 3 LEG ELECTRIC TABLE BASE ASSEMBLY ™ STEP 8 5mm Allen Key Attach a foot to each of the legs. • Use four M10x45 screws per foot. • Tighten the screws with an 5mm Allen key. M10x45 STEP 9 Adjust the position of the frame before attaching it to the work surface.
- Page 7 ASSEMBLY ALL-FLEX 3 LEG ELECTRIC TABLE BASE ™ STEP 10 Once the frame is in its final position, attach it to the work surface using the M5x18 screws (16 total required). • Attach the screws through the mounting tabs on the frame, center leg column, and center leg top supports, as well as the holes at the ends of the side column top supports.
- Page 8 ALL-FLEX 3 LEG ELECTRIC TABLE BASE ASSEMBLY ™ STEP 12 Attach the control unit to the work surface. M5x18 • Slide the control unit under the bracket and attach it using M5x18 wood screws. The motor cable and keypad ports should face away from the center column.
- Page 9 • If there are problems with operation, check that all cable and cord connections are secure. If problems continue, call ESI Customer Service. STEP 16 Use the pre-installed cable clips plus the additional clips provided, to secure the cables in position.
- Page 10 ALL-FLEX 3 LEG ELECTRIC TABLE BASE ASSEMBLY ™ STEP 17 With the assistance of a helper, turn the table upright and place it in its final position. IMPORTANT: There must be 1" (25mm) of clearance on all sides of the work surface (and other moving parts) to ensure free, unobstructed movement.
-
Page 11: General Operation
OPERATION ALL-FLEX 3 LEG ELECTRIC TABLE BASE ™ Memory Table DOWN Memory Buttons Button Height Button Buttons CAUTION: The “zero setting” procedure must be completed before operating the table. See Step 15 on page 9. GENERAL OPERATION Table movement stops when you Move the table up or down by pressing UP s or DOWN t until release the UP s or DOWN t button. - Page 12 800.833.3746 esiergo.com © 2017 ESI Ergonomic Solutions. All rights reserved. FLEX3-V1 Rev B 6/17...