Advertisement
Trada 2-leg
general operation
• Move the table by pressing the UP s button to raise it and the DOWN t
button to lower it.
• The table will continue to move up or down until you release the button,
until the maximum or minimum height is reached, or until a memory stop is
reached.
Table movement stops when you release the button.
NOTE: The table must stop prior to reversing directions.
memory stop positions
Upper and lower memory stop positions can be used to save specific
heights of the worksurface. To set a specific position:
• Raise or lower the table to the first position you want to save.
• Press the UP s and DOWN t buttons simultaneously, and release.
• Repeat three times, waiting ½ to 1 second between each pressing.
• Then press the UP s button to set the upper limit or the DOWN t button
to set the lower limit.
• Repeat to set the second limit.
After setting each limit, the table will do a gentle rise to confirm the setting.
To move the worksurface to a memory stop position:
• Press the UP s or DOWN t button until the table stops. Release the button.
— If you continue to press the UP s or DOWN t button for five seconds
after the table stops, the table will continue to move up or down.
If you release the memory button before the saved position is reached, table
movement will stop.
To delete the memory stop positions:
• Perform a manual reset by pressing the UP s and DOWN t buttons
simultaneously for seven seconds.
• Then press the DOWN t button to move the table to its lowest level.
+
wait ½ to 1 second
+
wait ½ to 1 second, then:
press both buttons
for seven seconds
Page 10
DOWN t
button
UP s
button
+
wait ½ to 1 second
or
upper
lower
limit
limit
then press DOWN t
to lower table all the way
Operation
Advertisement
