Installation - Jøtul C 24 Installation And Operating Instructions Manual

The Jøtul C 24 has a fan solution that increases air circulation in
the convection chamber, thereby effectively warming the room
and providing enhanced comfort.

Installation

With access to the rear of the convection chamber.
Fig 1
A
B
C
A
• Unscrew the screws holding the fan cover for the
convection chamber (Fig 1A).
Remove the fan cover (Fig 1B).
•
• Unscrew the screw holding the side wall inside the inlet air
chamber (Fig 1C).
Remove the inlet air chamber side wall (Fig 1D).
•
Push out the cable slot (Fig 1E).
•
D
A
E
Fig 2
D
F
E
• Thread the cable with the female connector through the
slot in the fan cover (Fig 2A).
1. Use cable ties to secure the cable to the bracket on the
bottom of the fan cover (make sure there is enough cable
for the connector to fit) (Fig 2B).
2. Connect the male and female connectors (Fig 1B-C).
3. Put the fan unit into place (Fig 2D).
4. Secure the fan unit using the same screw that was holding
the side wall (Fig 1B-E).
5. Refit the fan cover and tighten all 5 screws (Fig 1B-F).
No access to the rear of the
convection chamber
Fig 3
1
Take out the side burn plates (Fig 3)
ENGLISH
C
A
B
2
7