Viewing The Face In The Dark; Using Auto Light; Configuring The Auto Light Setting - Casio 3481 Operation Manual

TIME+DAILY: Current Time + Weekly
Information
This screen shows the current time and your
weekly step count.
Daily steps
Daily step count goal progress
TIME+MONTHLY: Current Time + Monthly
Information
This screen shows the current time and your
running distance during the currently selected
month. Instead of running distance, you could
also specify display of running time. Note that
you must use "G-SHOCK MOVE" to specify
which item (running distance or running time)
should be displayed.
1 month's running distance or running time
Monthly step count goal progress
TIME+WORLD TIME: Current Time +
World Time
World Time City
World Time
Operation Guide 3481

Viewing the Face in the Dark

The watch has a light that illuminates the face
for viewing in the dark.
To illuminate the face manually
●
Press (B) to turn on illumination.
Illumination will turn off automatically if an
●
alarm starts to sound.

Using Auto Light

●
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
Important!
Auto Light may not operate properly
●
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
Electro-static charge or magnetism
●
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
When moving the watch you may note
●
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
Auto Light is disabled when any one of
●
the conditions below exists.
While an alarm sound, timer sound,
ー
and/or vibration operation is in
progress
If you do not disable it manually, Auto
●
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.

Configuring the Auto Light Setting

1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
40
degrees
or more
3.
Use (A) and (D) to move the pointer to
[LIGHT].
4.
Press (C).
5.
Use (A) and (D) to move the pointer to
[AUTO LIGHT].
6.
Press (C).
7.
Use (A) and (D) to move the pointer to
[OFF] (disabled) or [ON] (enabled).
The [LT] indicator is displayed in the
●
Timekeeping Mode while Auto Light is
enabled.
8.
Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the illumination
setting screen will re-appear.
9.
Press (E) twice to exit the setting screen.
5