Turning Off An Alarm; To Stop A Sounding Alarm - Casio 3481 Operation Manual

8.
Press (C).
9.
Use (A) and (D) to set the alarm hour.
10.
Press (C).
11.
Use (A) and (D) to set the alarm minute.
12.
Press (C).
13.
Use (A) and (D) to select whether or not
you want to save your current settings.
[YES] Saves current settings.
[NO] Discards current settings.
Returns to the alarm setting
[RETURN]
screen.
14.
Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the alarm setting
selection screen will re-appear.
Turning on an alarm causes
●
appear on the display to the right of the
time setting. If snooze is enabled, [SNZ]
also appears.
15.
Press (E) twice to exit the setting screen.
Note
To exit the alarm setting operation at
●
any point, press (E) and advance to
step 13.

To stop a sounding alarm

●
While an alarm sound and/or vibration
operation is being performed, press any
button to stop it.
Note
When snooze is enabled for an alarm,
●
alarm sound and/or vibration will
repeat every five minutes, up to seven
times. To stop an alarm's ongoing
snooze operation, turn off the alarm.
Operation Guide 3481

Turning Off an Alarm

To stop an alarm sound and/or vibration
operation, perform the steps below to turn it
off.
To reactivate an alarm sound and/or
●
vibration operation, turn it back on.
Note
An indicators is displayed while any
●
one of the alarms is turned on.
The alarm indicator is not displayed
●
while all of the alarms are turned off.
to
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
3.
Use (A) and (D) to move the pointer to
[ALARM].
4.
Press (C).
5.
Use (A) and (D) to move the pointer to the
alarm you want to turn off.
Pointer
6.
Press (C).
7.
Use (A) and (D) to select [OFF].
8.
Press (E).
9.
Use (A) and (D) to select whether or not
you want to save your current settings.
[YES] Saves current settings.
[NO] Discards current settings.
Returns to the alarm setting
[RETURN]
screen.
10.
Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the alarm setting
selection screen will re-appear.
11.
Press (E) twice to exit the setting screen.
Turning off all alarms will cause
●
(alarm) to disappear from the display.
Note
If (alarm) is still displayed, it
●
means that at least one of the other
alarms is still turned on. To turn off all
of the alarms repeat steps 5 through 10
until the (alarm) indicator is no
longer displayed.
23