Viewing The Face In The Dark - Casio GW-M5610U Operation Manual

Note
When [H], [M], and [L] are all flashing
●
on the display, it means that all
functions are disabled due to
momentary battery power
consumption.
Charging Time Guidelines
●
The table below shows guidelines for
approximate charging times.
Charging Times Required for 1 Day of
Operation
Approximate
Light Level (Lux)
Charging Time
50,000 8 minutes
10,000 30 minutes
5,000 48 minutes
500
Times Required to Achieve Next Charge
Level
Sunny day, outdoors (50,000 lux)
●
Dead battery Medium
n
charge
Medium charge High
n
charge
High charge Full charge
n
Sunny day, near a window (10,000 lux)
●
Dead battery Medium
n
charge
Medium charge High
n
charge
High charge Full charge
n
Overcast day, near a window (5,000 lux)
●
Dead battery Medium
n
charge
Medium charge High
n
charge
High charge Full charge
n
Indoor fluorescent lighting (500 lux)
●
Dead battery Medium
n
charge
Medium charge High
n
charge
High charge Full charge
n
Watch Operation Guide 3495
Note
Actual charging time depends on the
●
local charging environment.
Power Saving Function
●
Leaving the watch in a dark location for about
one hour between the hours of 10 p.m. and 6
a.m. will cause the display to go blank, and the
watch to enter Level 1 power saving. If the
watch is left in this condition for six or seven
days, the watch will enter Level 2 power
saving.
Power Saving Level 1 :
Digital display goes blank to save power.
Power Saving Level 2 :
Digital display goes blank to save power. All
functions are disabled.
8 hours
Recovering from Power Saving Operation
Use one of the operations below to exit power
saving.
Press any button.
●
Move the watch to a bright location.
●
3 hours
Trigger auto light by angling the watch
●
towards your face.
34 hours
Note
10 hours
The watch will not enter power saving
●
in the cases below.
While in the Stopwatch Mode
ー
10 hours
While in the Timer Mode
ー
You can enable or disable Power
●
130 hours
Saving as required.
Configuring Power Saving
l
35 hours
Function Settings
Note that the watch also may enter
●
power saving if its face is blocked from
light by your sleeve while you are
16 hours
wearing it.
210 hours
57 hours
206 hours
-
-

Viewing the Face in the Dark

The watch has a light that illuminates the face
for viewing in the dark.
To illuminate the face manually
●
Press (B) to turn on illumination.
Illumination will turn off automatically if an
●
alarm starts to sound.
Important!
Frequent use of illumination will run
●
down the battery.
Note
Display illumination is disabled when
●
any one of the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Time calibration reception in
ー
progress
To illuminate the face when Auto Light
●
is enabled
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
40
degrees
or more
7