Table of Contents
Advertisement
8.3
Operation via the Web Interface
8.3.1 Requirements
8.3.1.1
Hardware
The web interface operates on any common PC or Notebook with a network card or a
WLAN card.
8.3.1.2
Software
The web interface can be used with any common operating system, such as MS Windows,
Linux, OS X... and it also functions with any common browser.
So far, it has only been successfully tested with Firefox, Internet Explorer, Konqueror and
Opera.
8.3.1.3
Connection to the Sequence Controller AST6
The PC on which the web interface is operating can either be connected with the
sequence controller AST6 or via a common network.
Cross cables as well as uncrossed cables can be used for the direct connection; the
sequence controller AST6 recognizes them automatically and adjusts the connection
respectively.
8.3.2 Preparing to use the Web Interface
In order to use the web interface, the sequence controller AST6 as well as the browser
must be set in a manner that a TCP/Ip connection between both can be established and
the data exchange released.
8.3.2.1
Setting the Sequence Controller AST6
A set IP address must be set at the sequence controller AST6 (also refer to
and brief description "Initial steps for start-up"). They must be issued by the administrator
of the local network. At the time of delivery the following values are preset:
IP Address:
Subnetwork mask
Gateway:
8.3.2.2
Setting the Browsers/Operating Systems
The browser must have free access to the sequence controller AST6, meaning;
• the IP address of the sequence controller AST6 must be reachable.
• the HTTP protocol must not be deactivated
• a possible proxy for the IP address of the sequence controller AST6 (or local
addresses general) must be deactivated.
Furthermore, the browser cookies must accept the sequence controller AST6 and
javascript must be activated. In case of doubts contact your responsible EDV
representative.
10.10.25.100
255.255.0.0
10.10.20.9
32
System Menu
Advertisement
Table of Contents
Troubleshooting
