soundsation HYPER TOP Series User Manual page 17

Hyper TOP series User manual
As you can see by checking the drawings above, these brackets allow various angles
of inclination according to each speaker model. The set consists of a C-bracket (a), a
cylinder (b) to be inserted into the hole for pole on the bottom of the speaker, and
three screws (c) for fixing the parts. Follow the steps below for correct installation of the
bracket and speaker.
1. Draw marks on the wall corresponding to the two or three holes on the C-bracket,
and drill the wall using proper tools for the type of wall.
2. Secure the C-bracket to the wall using wall plugs and screws of adequate size to
support the weight of the speaker.
3. Remove the rubber caps (4a, 4b) located on the top and bottom of the speaker.
4. Insert the cylinder into the 36mm hole on the bottom of the speaker.
HYPER TOP 10A WALL-MOUNT BRACKET
40°
26.6°
13.3°
0°
556mm 85mm
-13.3°
-26.6°
-40°
4a
Ø=35mm
35mm
Ø=13mm
79mm
104mm
280mm
4b
ENGLISH
103mm
175mm
175mm
103mm
17