soundsation HYPER TOP Series User Manual page 13

Hyper TOP series User manual
6) Level 2
This controls the overall signal level at the stereo mini jack plug and RCA inputs.
7) High/Low
This 2-band EQ optimizes the frequency response in order to better adapt the speaker
to the environment in which it is used.
8) Level (Master)
This controls the overall signal level of all inputs, including the AUX Input.
9) POWER
When the POWER switch is turned on and the line-cord is connected to an active AC
Mains supply, this indicator is lit.
10) Limit
This LED lights up only when the input signal is too high and limiter operates in order
to prevent unwanted damage to amplifier or transducers.
NOTE: To better adjust levels and avoid limiter to intervene and cut signals,
once connected the desired sound source, slowly turn up LEVEL 1 or 2 and
MASTER LEVEL control until the desired volume is reached (and the LIMIT
light comes on occasionally). Always protect your hears if you are close when
it is playing at high levels.
11) Line Out
This is a male XLR-type connector that produces a "EQed" mix of both Mic/Line Inputs.
Please notice that this output is not affected by Master Level control. Use it to dai-
sy-chain several active speakers together.
12) Line In Input section
There is a pair of RCA plugs and a 1/8" mini jack plug that accept a unbalanced
line-level signals.
ENGLISH
13