soundsation HYPER TOP Series User Manual page 11

Hyper TOP series User manual
make sure the unit turned off and discon-
nected from the AC outlet.
Note: If you happen to loose the AC
line-cord, always use a three-pin plug
with a ground pin.
3) MIX Out
This is a male XLR-type connector that pro-
duces a EQed mix of both Mic/Line Inputs.
Use it to daisy-chain several active monitors
together.
4) MIC/LINE INPUT Section
There is a female XLR-type connector and
a 1/4" Jack plug that accept a balanced or
unbalanced mic- or line-level signal. The
switch Line/Mic has to be pressed in case of
microphone level signals. There is no phan-
tom power for a microphone, so you should
use a dynamic mic, or use a condenser type
if it has its own battery power.
WARNING: Pressing MIC/LINE switch
on line level signals may cause dam-
ages to the speaker. Be careful!
5) MIC/Line LEVEL
This controls the overall signal level at the Mic-Line inputs.
6) EQ
This 2-band EQ optimizes the frequency response in order to better adapt the speaker
to the environment in which it is used.
7) CLIP indicator
This LED lights up only when the input signal is too high and limiter operates in order
to prevent unwanted damage to amplifier or transducers.
NOTE: To better adjust levels and avoid limiter to intervene and cut signals,
once connected the desired sound source, slowly turn up LEVEL control until
the desired volume is reached (and CLIP light comes on occasionally). Always
protect your hears if you are close when it is playing at high levels.
8) POWER ON Indicator
When POWER switch is turned on, and the line-cord is connected to an active AC Mains
supply, this indicator is lit.
MIC/LINE level
input mic/line
4
0
LINE
3
MIC
link
out
HYPER TOP 8A
AC INPUT
AC 230V 50HZ
T2.0A/250V
2
ENGLISH
5 6
EQ
high
10 -10 +10
low
7
-10 +10
POWER CLIP
8
Power
1
ON
OFF
11