Mounting Terminal Boards - Watlow Anafaze PPC-2000 User Manual

Chapter 2: Hardware Installation
Panel Mounting

Mounting Terminal Boards

28
The PPC modules may be panel mounted using the mounting
holes located on the end plates. The width of a system varies
depending on the number of modules. Consult Figure 7.1 on
page 230 to determine installed clearances.
To panel mount the modules:
1. Locate a space with sufficient room for the appropriate
number of modules and connecting wires. Refer to Figure
7.1 on page 230 for a system footprint and dimensions.
2. The mounting holes are located on the end caps of the
module assembly. Mark each mounting hole.
3. Drill and tap the four #10 mounting holes.
4. Place the modules such that the holes are aligned, insert
the screws and tighten them.
Terminal boards support interfacing field I/O devices with the
PPC modules. All terminal boards may be DIN rail or panel
mounted. The following sections provide procedures for
mounting the terminal boards.
There are smaller holes on each terminal board that may be
used to secure wiring with tie wraps.
Refer to Figure 2.13 on page 29 for AITB dimensions.
Refer to Figure 2.14 on page 30 for EITB dimensions.
Refer to Figure 2.15 on page 31 for TB50 dimensions.
Watlow Anafaze
PPC-2000 User's Guide
Doc.# 30002-00 Rev 2.3