Weider WESY29510 User Manual page 12

21. Route the Long Cable (41) over a 3 1/2" Pulley
(45). Attach the Pulley and a Cable Trap (44) to
the bracket on the Top Frame (10) with a 3/8" x 2"
Bolt (74) and the 3/8" Nylon Locknut (84). Be
sure that the Cable is in the groove of the
Pulley and that the Cable and Pulley move
smoothly.
22. Attach the Long Cable (41) to the Small "U"-
Bracket (25) with a 1/4" Nylon Locknut (82) and a
1/4" Washer (81). See the inset drawing. Do not
overtighten the Nylon Locknut; it should be
threaded onto the end of the Cable only two
turns, as shown.
Attach the Small "U"-Bracket (25) to the Weight
Tube (26) with the 5/16" x 1 3/4" Bolt (75) and a
5/16" Nylon Locknut (83).
23. Locate the Short Cable (42). Route the Short
Cable under a Pro 3 1/2" Pulley (94). Attach the
Pulley and the 5/8" x 9/16" Spacer (58) to the
lower hole in the Press Frame (13) with a 3/8" x 3
3/4" Bolt (70), a 3/8" Washer (86), and a 3/8"
Nylon Locknut (84). Be sure that the end of the
Cable with the ball is on the indicated side of
the Pulley.
24. Wrap the Short Cable (42) around a 3 1/2" Pulley
(45). Attach the Pulley and a Cable Trap (44) to
the lower hole in the Front Upright (4) with a 3/8"
x 3 3/4" Bolt (70), a 3/8" Washer (86), and a 3/8"
Nylon Jamnut (92). Be sure that the Cable Trap
is turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown.
21
Bracket
10
84
22
41
25
82
23
84
94
Ball
58
42
24
70
86
12
74
45
44
41
25
83
86
13
70
4
44
45 92
42
41
75
81
82
26