Table of Contents
Advertisement
Maintenance
7.11 Removing and Attaching
the Soft Vinyl Seating
To remove the seating:
1.
Unfasten the snap at each corner of the vinyl at the top
of the backrest (Figure 44).
2.
Lay chair on its back and unbuckle both retaining
straps beneath the seat (Figure 45).
3.
Unfasten the four snaps on the vinyl flap beneath the
seat at the front of the chair (Figure 46).
4.
Lift the cover off the chair and return the chair to the
upright position.
To attach the seating:
1.
Fasten the snap at each corner of the vinyl at the top
of the backrest.
2.
Lay chair on its back and fasten the buckles of both
retaining straps.
3.
Fasten the four snaps on the vinyl flap beneath the seat
at the front of the chair.
4.
Pull the free end of each buckled retaining strap until
the strap is tight (Figure 47), then return the chair to
the upright position.
30
Snaps
Figure 44 - Unfasten Snaps
Figure 45 -
Unbuckle Straps
Snaps
Figure 46 - Unfasten Seat Snaps
Figure 47 - Tighten
Straps
© Ferno-Washington, Inc 234-3298-02 May 2009
59, 59-T EZ Glide®
Advertisement
Table of Contents
