Lubricating The Chair - Model 59-T And Model 59; Do Not Lubricate Track System On Model 59-T; Figure 33 - Label On Chair Track - Ferno EZ Glide 59-T Series User Manual

59, 59-T EZ Glide®
7.6 Lubricating the Chair -
Model 59-T and Model 59
Disinfect and clean the chair before applying lubricant.
There are two identical lubrication points on the chair. They
are located where the brass bushing in the chair lock bar slot
meets the stainless steel slide in the chair leg (Figure 32).
Lubricate each lubrication point with one drop
of SAE 30-weight oil, then move the lock bar
back and forth a few times to work the oil into
the slide. Remove any excess lubricant with
SD-20 Cleaner.

Note: To order SD-20 Cleaner, call Spartan Chemical
Company at 1.800.537.8990.
Important
Lubricating parts that should not be lubricated allows
dirt and foreign particles to collect on those parts,
resulting in damage. Lubricate only the numbered
reference points shown.
7.7 Do Not Lubricate Track System
on Model 59-T
Never lubricate the track, the track belts, or any other
part of the track system. Lubricants on the belts or track
can cause the chair to perform unpredictably, resulting in
injury to the patient and/or operators.
A label (Figure 33) instructing the user not to lubricate the
track system is affixed to each side
of the track. If these labels become
damaged or worn, replace them
immediately (see Parts and Service,
page 32 and 33).
If track or belts pick up oil or grease
during use or while the chair is being serviced, clean the
track and belts with SD-20 All-Purpose Cleaner before using
the chair again. See Cleaning Track and Belts, page 23, for
cleaning instructions.
© Ferno-Washington, Inc 234-3298-02 May 2009
Lubricate
Do Not Lubricate
Figure 32 -
Top: Lubrication Point Locations
Bottom: Lubrication Point Close-up
WARNING
Lubricating the track system can result in injury to
patient and/or operators. Never lubricate the track
or belts.

Figure 33 - Label on Chair Track

Maintenance
25