Table of Contents
Advertisement
59, 59-T EZ Glide®
4.3 Ankle Restraint
Attach the two-piece ankle restraint to the front legs of the
chair. To attach the restraint:
1.
Unbuckle the restraint to separate the straps.
2.
Wrap a strap around one front leg of the chair and
thread the buckle through the loop (Figure 4).
3.
Pull the strap until the looped end is tight around the
chair leg (Figure 5).
4.
Attach the remaining strap to the other front leg of the
chair.
5.
Buckle the restraint and adjust the length (Figure 6).
4.4 Attaching Restraints to Chair
With Soft Vinyl Seating
With soft vinyl seating, use the criss-cross restraint
configuration plus a lap restraint (Figure 2, page 10). To
attach the restraints:
1.
Unbuckle a restraint to separate the straps.
2.
Attach the strap with the female buckle piece to the left
or right side of the backrest frame (Figure 7). Follow
instructions in the restraint users' manual for attaching
a two-piece restraint.
3.
Attach the strap with the male buckle piece to the
exposed area of the seat frame on the opposite side of
the chair.
4.
Repeat steps 1-3 to attach the second torso restraint.
5.
Attach a lap restraint alongside the restraints already
attached to the seat frame.
6.
Fasten and adjust the restraints.
© Ferno-Washington, Inc 234-3298-02 May 2009
Figure 4 - Threading Buckle Through Loop
Figure 5 - Tightening Strap
Figure 6 - Ankle Restraint Attached
Figure 7 - Torso Restraints on Chair
with Soft Vinyl Seating
Chair Setup
11
Advertisement
Table of Contents
