Weider WEBE44490 User Manual page 10

12. Press two 3/4" Round Inner Caps (54) into each of
the three Pad Tubes (38).
Slide a Foam Pad (10) onto one end of each Pad
Tube (38).
Insert the free end of each Pad Tube (38) into the
indicated holes in the Leg Lever (18) and the bracket
on the Front Leg (19). Secure each Pad Tube by slid-
ing another Foam Pad (10) onto the free end.
13. Locate the Cable (45) and note that it has a loop on
one end and a ball on the other end. Insert the end
with the loop through the slot in the Lat Tower (9)
from the direction shown. Make sure the Cable is
routed through the bracket exactly as shown.
Next, lay the Cable (45) in the groove of the Pulley
(35). Attach the Pulley inside the slot in the Lat Tower
(9) with the M10 x 68mm Bolt (34), two M10 Washers
(6), two Pulley Spacers (41), and an M10 Nylon
Locknut (11).
Press a 2" Square Inner Cap (17) into the top of the
Lat Tower (9).
14. Press Carriage Bushings (2) onto the top and bottom
of the Weight Carriage (47). Press a 1" Round Inner
Cap (12) into the weight tube on the Weight Carriage.
Insert the M10 x 19mm Bolt (46) into the bracket on
the Weight Carriage (47) from the indicated direction.
Press the last Carriage Bushing (2) into the Carriage
Stop (24) as shown.
12
54
38
10
18
54
38
54
13
34
41
35
14
Bracket
12
Weight
Tube
10
19
54
10
38
54
10
45
17
6
Bracket
11
6
41
9
2
46
47
2
10
2
24