Care And Maintenance - Sharp FP-J40A Operation Manual

CARE AND MAINTENANCE

To maintain optimum performance of this air purifi er, please clean the main unit including the fi lter periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
Do not WASH
ACTIVE CARBON
DEODORIZING FILTER
When the smell from the Air Outlet
When the smell is hard to take
Pre-Filter ( Back Panel )
Once in a month
When the fi lter reset indicator light is on
Pre-Filter
Pre-Filter
( Back Panel )
After
Please reset the fi lter reset indicator
after cleaning.
more than 3 sec.
SENSORS
Dust sensor
Dust sensor
fi lter
Odor sensor
Odor sensor
OM_FP-J40A.indd 8
SENSORS
HEPA FILTER
When the smell from the Air Outlet
When the smell is hard to take
( Back Panel )
Gently remove dust from the Pre-Filter ( Back Panel ) with a vacuum
cleaner attachment or similar tool.
CAUTION
Do not apply excessive pressure when scrubbing the Pre-Filter ( Back
panel) .
NOTE
Once in
two months
How to clean hard to remove dirt
1. Add a small amount of kitchen
Pre-Filter
detergent to water and soak for
( Back Panel )
about 10 minutes.
2. Rinse off the kitchen detergent
with clean water.
3. Completely dry the fi lter in a
well-ventilated area.
1. Remove the Pre-Filter ( Back Panel ).
2. Remove the Dust Sensor Filter.
3. If it is very dirty, wash it with water and dry it thoroughly.
Gently remove dust from the odor sensor by using a
vacuum cleaner attachment or similar tool.
EN-8
MAIN UNIT
Once in
two months
2018/09/28 12:02:08