Weider WEBE13010 User Manual page 7

3. Attach the Bottom Crossbar (15) to an Upright
Base (3) with two 3/8" x 2.85" Bolts (23), four 3/8"
Washers (18), and two 3/8" Nylon Locknuts (19).
Do not tighten the Nylon Locknuts yet.
Attach the Bottom Crossbar (15) to the other
Upright Base (3) in the same manner.
4. Attach an Angled Support (7) to a Stabilizer (5)
with a 3/8" x 2.85" Bolt (23), two 3/8" Washers
(18), and a 3/8" Nylon Locknut (19). Attach the
Angled Support to the Upright Base (3) with a
3/8" x 2.85" Bolt, two 3/8" Washers, and a 3/8"
Nylon Locknut. Do not tighten the Nylon
Locknuts yet.
Attach the other Angled Support (7) to the other
Stabilizer (5) and Upright Base (3) in the same
manner.
5. Press a Rubber Endcap (14) onto the end of an
Upright (2). Orient the Upright as shown and
attach it to an Upright Base (3) with two 3/8" x
3/4" Bolts (22) and two 3/8" Washers (18). Note:
the Bolts must be attached to the lower set of
holes in the Upright and Upright Base. Do not
tighten the Bolts yet.
Attach the other Upright (2) to the other Upright
Base (3) in the same manner.
3
23
18
18
19
18
4
23
18
18
7
19
18
19
5
2
22
18
3
7
3
15
23
3
23
18
5
3
14
18
22