Compressor Oil Charge; Electrical Connection; Three-Phase Power Supply; Tab. 14 Compressor Oil Recommendation - KAESER EPC-G Series Assembly And Operating Manual

Tab. 14
2.10.1
Tab. 15
2.11
2.11.1
8
2 Technical Specifications
2.11

Electrical connection

➤ Mark the oil that your compressor contains in the table below.
Oil type
Application
Oil contained in my
compressor
Compressor oil recommendation

Compressor oil charge

Compressor model
EPC 340-G
EPC 440-G
EPC 630-G
EPC 840-G
EPC 1100-G
EPC 1500-G
Compressor oil charge
Electrical connection
Basic requirements
The machine is designed in accordance with the conditions for an electrical power supply specified
in EN 60204-1 (IEC 60204-1) section 4.3.
If no other conditions are specified by the operator, the thresholds described in this standard must
be adhered to.
It is recommended that the user and the supplier reach an agreement on the basis of EN 60204-1,
Annex B.
Check and adjust for other deployment conditions before commissioning.
If the machine is supplied with a mains cable and a plug, the power socket may be fused at
the nominal current of the plug device.

Three-phase power supply

The machine requires a symmetrical three-phase power supply.
In a symmetrical three phase supply the phase angles and voltages are all the same.
This machine may only be supplied from an earthed TN or TT three-phase supply in which the
neutral point is earthed.
Assembly and operating manual
EPC-G
Standard oil
EPC 340/ EPC 630 –
EPC 440 EPC 1500
SAE 5 W30 VDL 150
Standard oil for all ap‐ Standard oil for all ap‐
plications except in plications except in
connection with food‐ connection with food‐
stuff. stuff. May contain
traces of silicone.
Total charge [litres]
0.2
1.1
1.4
1.24
1.5
1.5
1-stage piston compressor
Special oil
FGP
Specially for use in
compressors where the
air may come into con‐
tact with foodstuff.
Topping up volume [l]
(minimum–maximum)
0.1
0.25
0.22
0.22
0.37
0.37
No.: 9_5752 24 E