Weider 9300 PRO User Manual page 7

4. Insert the two 5/16Ó x 2 3/4Ó Bolts (55)
through the two indicated 5/16Ó Washers (20),
and into the Curl Post (9).
Slide the Seat Frame (8) onto the ends of the
Bolts (55) and secure the Seat Frame with
two 5/16Ó Nylon Locknuts (40).
Press a 2Ó Square Inner Cap (56) into the top
of Curl Post (9).
5. Slide the Curl Post (9) onto the indicated
5/16Ó x 2 1/2Ó Carriage Bolts (49) in the Press
Base (13). Hand tighten two 5/16Ó Nylon
Locknuts (40) onto the Carriage Bolts.
Attach the Seat Frame (8) to the Press
Upright (4) with two 5/16Ó x 2 3/4Ó Bolts (55),
two 5/16Ó Washers (20), and two 5/16Ó Nylon
Locknuts (40). Do not tighten the Nylon
Locknuts yet.
6. Insert two Weight Guides (23) into one of the
brackets on the Weight Base (14). Attach the
lower end of the Weight Guides with a 5/16Ó x
6Ó Bolt (67), two 1/2Ó x 3/4Ó Spacers (69), and
a 5/16Ó Nylon Locknut (40). Do not over
tighten the Nylon Locknut.
Attach the other Weight Guides (23) to the
other bracket in the same manner.
7. Slide a Weight Bumper (27) onto each of the
Weight Guides (23).
Slide eight Weights (89) onto each set of
Weight Guides (23). Be sure that the pin
grooves are on the indicated side of each
stack of Weights.
4
8
20
5
55
20
4
6
40
14
7
89
Pin
Grooves
27
23
7
40
56
20
40
9
20
40
8
40
9
40
13
49
23
23
67
69
89
Grooves
27
23
55
40
Pin