Misc. - Weider 9300 PRO User Manual

50. Press two 3/4Ó Round Inner Caps (78) into
each Pad Tube (28).
Insert a Pad Tube (28) into the Rear Seat
Frame (16). Slide a Foam Pad (29) onto each
end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg
Lever (15). Slide a Foam Pad (29) onto each
end of the Pad Tube.
51. Attach the Large Backrest (19) to the Press
Upright (4) with two 1/4Ó Washers (37) and
two 1/4Ó x 2 1/2Ó Machine Screws (64).
Remove the ÔWEIDER 9300 PROÕ decal from
the backing paper and apply the decal to the
Press Upright (4) above the warning decal,
where shown.
52. Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (60) into a
Seat Plate (41). Attach the Seat Plate to the
Seat (17) with two 1/4Ó x 3/4Ó Screws (59).
Attach the Seat (17) to the Seat Frame (8)
with a 1/4Ó Washer (37) and a 1/4Ó x 2 1/2Ó
Machine Screw (64). Slide a 1/4Ó Washer (37)
onto the 1/4 x 2 1/2Ó Carriage Bolt (60) and
tighten a 1/4Ó Nylon Locknut (44) onto the
Carriage Bolt.
See the inset drawing. Attach the Curl Pad
(11) to the Curl Pad (10) with two 1/4Ó x 3/4Ó
Screws (59).
53. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained
in HOW TO USE THE TRAINING SYSTEM, beginning on page 21 of this manual.
Before using the training system, pull each cable a few times to be sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPOR-
TANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See the CABLE DIAGRAMS on page 25 and 26 of this manual for proper cable routing. If
there is any slack in the cables, you will need to remove the slack by tightening the cables. See
TROUBLE-SHOOTING AND MAINTENANCE on page 24.
50
78
29
15
51
64
37
52
59
10
20
16
28
29
78
WEIDER 9300
PRO decal
4
19
11
37
64
44
17
60
41
59