Weider 9300 PRO User Manual page 12

20. Wrap the Butterfly Cable (88) around a 3 1/2Ó
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the bracket on the Press
Upright (4) with a 3/8Ó x 2Ó Bolt (50) and a
3/8Ó Nylon Locknut (42). The Cable Trap
must be oriented as shown and be posi-
tioned to hold the Cable in the groove of
the Pulley.
21. Locate one of the preassembled pairs of
Pulley Plates (31) and 3 1/2Ó Pulleys (82).
Route the Butterfly Cable (88) under the indi-
cated 3 1/2Ó Pulley (82). The end of the Pulley
Plates (31) with two holes should be down-
ward. Be sure that the Cable is between
the Cable Trap (80) and the Pulley, and that
the Cable Trap is positioned to hold the
Cable in place. Refer to the inset drawing.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó
Nylon Locknut (not shown).
22. Wrap the Butterfly Cable (88) around a 3 1/2Ó
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the other side of the bracket
on the Press Upright (4) with a 3/8Ó x 2Ó Bolt
(50) and a 3/8Ó Nylon Locknut (42). The
Cable Trap must be oriented as shown and
be positioned to hold the Cable in the
groove of the Pulley.
23. Note: The Left Fly Arm (6) is shown
removed for easier part identification.
Insert a 5/16Ó x 1Ó Bolt (51) through the brack-
et on the Left Fly Arm. Fully tighten a 5/16Ó
Nylon Jam Nut (90) onto the Bolt.
Slide the free end of the Butterfly Cable (88)
onto the 5/16Ó x 1Ó Bolt (51). Thread another
5/16Ó Nylon Jam Nut (90) onto the Bolt. Do
not fully tighten the Jam Nut; leave
enough room between the two Jam Nuts
for the Cable to pivot.
20
21
88
82
31
22
23
88
51
12
42
82
50
80
88
88
50
End with
two holes
should be
down
80
50
42
88
82
4
90
6
4
80