Table of Contents
Advertisement
31. Wrap the Press Cable (87) around a ÒVÓ
Pulley (81). Attach the ÒVÓ Pulley to the upper
bracket on the Press Upright (4) with a 3/8Ó x
2 1/4Ó Bolt (71) and a 3/8Ó Nylon Jam Nut
(43).
32. Route the Press Cable (87) up around the
indicated 3 1/2Ó Pulley (82) that is attached
inside the Press Frame (12). Be sure that
the Cable Trap (80) is turned to hold the
Cable in place and that the Cable is
between the Pulley and the crossbar on
the Press Frame. Tighten the 3/8Ó Nylon
Locknut (not shown) and the 3/8Ó x 3 1/2Ó Bolt
(66).
33. Route the Press Cable (87) around a 3 1/2Ó
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Press Upright (4) with a 3/8Ó
x 3 3/4Ó Bolt (76), a 3/8Ó Washer (38) and a
3/8Ó Nylon Jam Nut (43). Be sure that the
Cable Trap is turned to hold the Cable in
place.
34. Route the Press Cable (87) over the indicated
3 1/2Ó Pulley (82) attached to the Pulley
Plates (31). The Cable must be routed in
the direction shown.
Refer to the inset drawing. Be sure that the
Cable is between the Cable Trap (80) and
the Pulley, and that the Cable Trap is posi-
tioned to hold the Cable in place.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó
Nylon Locknut (not shown).
31
4
81
71
87
43
32
87
82
80
4
66
12
33
43
38
82
87
76
80
4
34
87
31
82
50
87
80
Page 15
Hide quick links:
Advertisement
Table of Contents
