Weider 9300 PRO User Manual page 10

14. Attach a Press Arm (7) to one side of the
Press Frame (12) with two 5/16Ó x 2 1/2Ó Bolts
(39) and two 5/16Ó Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press
Frame (12) in the same manner.
15. Press a 1Ó Round Inner Cap (70) into one of
the Press Arms (7). Press a 1 3/4Ó Square
Inner Cap (48) into the Press Arm.
Repeat this step for the other Press Arm (not
shown).
16. Lubricate both axles on the Butterfly Frame (3).
Refer to the drawing and identify the Right Fly
Arm (5) and the Left Fly Arm (6).
Press a 1 3/4Ó Square Inner Cap (48) into the
upper end of the Left Arm (6). Slide the Left
Fly Arm onto the indicated axle. Note: Be
careful not to confuse the Left Arm with
the Right Arm (5). Be sure that the upper
end of the Left Arm is behind the indicated
bracket on the Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the
1Ó Retainers (45) used in this step, be sure
that you thoroughly understand the step.
The Retainers can be assembled only once.
If they must be removed, you will need to
order new Retainers.
Tap two 1Ó Retainers (45) and a 1Ó Round
Outer Cap (46) onto the axle. Be sure that
the teeth on the Retainers bend toward the
Round Outer Cap, as shown in the inset
drawing.
Attach the Right Fly Arm (5) in the same
manner.
14
7
15
16
5
Bracket
10
39
7
40
12
48
70
7
3
Lubricate Axle
48
45
46
6
45
Axle
46