Weider 831.153930f User Manual page 18

49. Wrap the Swivel Low Cable (72) over a 3 1/2"
Pulley (78). Attach the Pulley and a Cable Trap (68)
between the lower set of holes in the "U"-bracket
(64) with a 3/8" x 2" Bolt (100) and a 3/8" Nylon
Locknut (87). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
50. Attach the end of the Swivel Low Cable (72) inside
of the Short Base (2) with a 5/16" x 2 1/2" Bolt (59),
two 5/16" Washers (90), and a 5/16" Nylon Locknut
(86).
51. Locate the Squat Cable (73), which is the only
remaining cable. Attach the eyelet end of the
Cable inside of the Long Base (120) with a 5/16" x
2 1/2" Bolt (59), two 5/16" Washers (90), and a
5/16" Nylon Locknut (86).
52. Wrap the Squat Cable (73) over a 3 1/2" Pulley
(78). Attach the Pulley, a Cable Trap (68), and two
3/4" Spacers (124) between the indicated brackets
on the Squat Slider (38) with a 3/8" x 3 1/4" Bolt
(96) and a 3/8" Nylon Jamnut (113). Make sure
that the Cable Trap is turned to hold the Cable
in the groove of the Pulley.
49
50
86
51
59
52
18
100
64
68
87
72
78
90
72
90
59
2
73
86
90
120
90
68
124
78
124
38
96
73
113