34. Remove the preattached 3 1/2" Pulleys (78) from
the Double "U"-bracket (62).
Wrap the Butterfly Cable (69) under a 3 1/2" Pulley
(78). Attach the Pulley to the Double "U"-bracket
(62) with a 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon
Locknut (87).
35. Wrap the Butterfly Cable (69) over a "V"-pulley (55).
Attach the Pulley and a Long Cable Trap (102) to
the other bracket on the Butterfly Upright (3) with a
3/8" x 2 1/2" Bolt (18) and a 3/8" Nylon Locknut
(87). Make sure that the Long Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
36. Attach the Butterfly Cable (69) to the Pivot Bracket
(70) on the Right Butterfly Arm (26) with a 5/16" x 1"
Shoulder Bolt (103) and a 5/16" Nylon Locknut (86).
37. Locate the Leg Lever Cable (75), which is 98 1/2"
long and has an eyelet on one end and a thread-
ed pin on the other end. Route the eyelet end of
the Cable through the Seat Upright (9) and attach it
to the tab on the Leg Lever (10) with a 5/16" x 1"
Shoulder Bolt (103) and a 5/16" Nylon Locknut (86).
38. Attach a 3 1/2" Pulley (78) inside of the Seat
Upright (9) with a 3/8" x 2 3/4" Bolt (101), two 3/8"
Washers (91), two 1/2" Spacers (89), and a 3/8"
Nylon Locknut (87), as shown.
34
93
35
18
102
69
55
36
103
26
37
86
10
103
38
91
89
87
15
69
78
87
62
3
87
69
70
86
75
9
75
78
91
101
89