Weider 831.153930f User Manual page 16

39. Route the Leg Lever Cable (75) under a 4 1/2"
Pulley (119). Attach the Pulley and a Large Cable
Trap (121) to the indicated side of the Butterfly
Upright (3) with a 3/8" x 3 3/4" Bolt (122), a 3/8"
Washer (91), and a 3/8" Nylon Jamnut (113). Make
sure that the Large Cable Trap is turned to hold
the Cable in the groove of the Pulley.
40. Wrap the Leg Lever Cable (75) over a 3 1/2" Pulley
(78). Attach the Pulley to the Double "U"-bracket
(62) with a 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon
Locknut (87).
41. Remove the preattached 3 1/2" Pulley (not
shown) from the "U"-bracket (64).
Attach the end of the Leg Lever Cable (75) to the
"U"-bracket (64) with a 1/4" Washer (97) and a 1/4"
Nylon Locknut (34). Note: Do not completely
tighten the Locknut; it should be threaded only
two turns onto the end of the Cable.
42. Locate the Swivel Low Cable (72), which is the
only remaining cable that has an eyelet on one
end and a ball on the other end. Route the eyelet
end of the Cable through the cage on the Long
Base (120) and through the Swivel Upright (5) as
shown.
Attach a 3 1/2" Pulley (78) to the indicated bracket
on the Long Base (120) with 3/8" x 1 3/4" Bolt (93)
and a 3/8" Nylon Locknut (87).
43. Wrap the Swivel Low Cable (72) under a 3 1/2"
Pulley (78). Attach the Pulley to the indicated brack-
et on the Long Base (120) with a 3/8" x 1 3/4" Bolt
(93) and a 3/8" Nylon Locknut (87).
39
122
121
40
41
42
78
72
Cage
120
93
43
78
120
93
16
119
3
75
113
91
93
87
62
75
78
75
64
97
34
87
5
72
87