Table of Contents
Advertisement
Electronic board description
1
without function
2
without function
3
DIP SWITCH 6: 1 (Default command) - 0 (SPCM)
4
without function
Set point humidity sensor. No function in case of
5
connection of the SPCM-1 Module
6
USB connector (for software updates)
7
temperature sensor
8
humidity sensor
9
extract fan
10
supply fan
11
power supply motors (230V/50Hz)
12
without function
13
outgoing error signal
Command connection / SPCM-1 Communication
14
module
SPCM-1 COMMUNICATIONS MODULE: (optional)
The SPCM-1 communications board will allow you to con-
nect the ALTAIR unit with the S&P IoT Platform: CONNEC-
TAIR.
To connect the SPCM-1 module to the ALTAIR you must fi rst
disconnect the control (14) and then connect the SPCM-1
with the cable supplied to the same terminal block (14).
In order to activate the SPCM-1 Module, you must change
the position of DIPSWITCH NO. 6 in the bank of 6 dipswit-
ches from position 1 to position 0.
The communications module box can be attached to the ALTAIR for the Velcro type element.
We recommend sticking it to one of the sheet metal braces to ensure its correct fi xation. If it is not possible, two
screws with their respective plugs are attached to be fi xed to the wall.
To allow the output of ALTAIR to the Internet, you must fi rst connect it to your router. The SPCM-1 communications
module has a wired (ETHERNET) or wireless (WIFI) connection. Follow the instructions you will fi nd in the module
box.
11
Advertisement
Table of Contents
