GRAPHTEC FCX4000 Series Setup Manual page 6

To make 1 cut with set value
4
Make test cutting for one piece while Tool conditions are
being set.
(1) Press the POSITION ( ) key (CUT TEST).
(2) Press the POSITION (
carriage to the location you wish to perform the test cutting.
Press the [ENTER] key.
1 cut test pattern is cut.
5
Check if the cut test is appropriate.
Adjustment of Offset
Check the corners of the triangles and rectangles. See "Setting the Tool
corner is not cut or if it is cut too much.
Adjustment for Half Cutting
If the backing sheet has been cut through, either the FORCE setting is
too high or the cutter-blade tip is extended too far. If the backing sheet
shows only a few traces of the cutter blade, either the FORCE setting is
Adjustment for Cutting Out
If the media is not completely cut, either the FORCE setting is too low or
extended.
Adjustment When Using Plotting Pen
set the FORCE to the lowest setting without any faint lines. See "Setting
) keys to move the tool
CAUTION
When the [ENTER] key is
pressed, the tool carriage will
start moving, so take care not
To make 3 cuts with set value and ±1 of set value
4
Make test cutting for three pieces while Tool conditions
are being set.
(1) Press the POSITION ( ) key (CUT TEST).
CUT TEST screen is displayed.
(2) Press the POSITION (
carriage to the location you wish to perform the test cutting.
(3) Press the [1] key (FORCE).
3 cutting test patterns are cut,
with current FORCE in the
center, and 1 each of FORCE
increased and decreased for 1.
(4) Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
(5) Press the [2] key (CUTTER OFFSET).
3 cutting test patterns are cut, with current CUTTER
OFFSET in the center, and 1 each of CUTTER OFFSET
increased and decreased for 1.
(6) Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
How to check offset
Check if the offset value is set correctly by
following.
6
) keys to move the tool
Cut Order
+1 Setting
values
Increase the offset value.
Optimal offset value.
Decrease the offset value.
www.delinit.by
-1