Table of Contents
Advertisement
The input parameters are grouped together in two programming
levels:
Access the first programming level by pressing
the
and
Then use the
to be changed.
Access the second programming level by pressing
the
and
for 5 seconds.
To exit from the programming levels and save the data, press the
key after the last input parameter.
If no key is pressed in either of the programming levels for
10 minutes, this mode will be exited without the data being saved.
Do not display altered parameter values before saving the data as it
will be reset to its former value.
6.4 Setting the cold store temperature
Press and hold down the
in question using the
Adjustment is possible within the limits of the input parameters E12
and E13.
The factory setting is +4 °C.
6.5 Changing the cold store temperature difference,
defrost cycle and alarm temperature
Access to the first programming level:
Press and hold down the
approx. 5 seconds
(E01 appears in display).
Setting: Press and hold down the
Adjust the setpoint value to the desired figure
using the
Input parameters and input ranges:
Parameter in display
(
or
)
E01 Cold store temp. difference
E02 Time between 2 defrost cycles
E03 Alarm temperature difference
keys at the same time for 5 seconds.
and
and the
key. Adjust the setpoint for the value
or
key.
and
or
key.
11
keys to access the parameters
key simultaneously
keys at the same time for
key.
Setting range
(
and
1 to 20 K
1 to 24 hours
–50 K to +50 K
or
)
Preset
2 K
8 hours
20 K
Hide quick links:
Advertisement
Table of Contents
