Settings; Setting Span Values; Set Date Or Time; Programs - MSA Ultima Controller Manual

Settings

Setting Span Values

• Ready
• Send
• Span
• Use +/- for gas list (i.e. 500 ppm CO)
• Enter
• Put in number (i.e. 300)
• Aim
• Enter

Set Date or Time

• Press and hold Date or Time
• Prompt appears
• Put in new date or time
• Enter
Send Date or Time
• Send
• Aim
• Date or Time

Programs

You can create Programs 1–9 for repetitive items. (See Manual)
Example
• Press and hold 'PROGRAM' button until 'Enter Program #'
• Enter number '1 – 9'
• Enter
• Ready
• Hit keystrokes and listen for 2 beeps
• Send
• Display
• + / -
• Previous Cal Date
• Enter (saving)
Setting Alarm Values
• Ready
• Send
• Alarm
• 0 – set point
• Use +/- for gas type
• Enter
• Point #
• Enter
• Point value
• Aim
• Enter
Reset Latched Alarms
Send any command and it will reset a latched alarm once it is
below the alarm value.
Send Average Time Interval
• Ready
• Send
• Average
• Use +/- for 1, 8, 24 hours
• Aim
• Enter
Program Run Program O
• Press 'PROGRAM' • Repeats last
command
• Enter #
• Press 'PROGRAM'
• Aim
• Enter '0'
• Enter
• Aim
• Enter
www.MSAgasdetection.com
• 1 – On/Off
• Use +/- for gas type
• Enter
• Point #
• Enter
• (Alarm prompt) or OR
• 1 – Enable 0 – Disable
• Latched / non-latch
Clear Programs
• Hold in #0
• Reset Prompt
Yes/No
• Aim
• Press 0 = N, 1 = Y