Transient Modules 2M Diy Building Manual page 5

DIY building manual - Version 1.3
18. Use your hands to screw the 10mm
spacer to the panel using the hexagonal M2
screw (the one which is slightly tiny).
19. Place the front panel moving a little the
parts if necessary.
20. The spacer in the panel must match the
hole in the PCB. Join both using the phillips
M2 screw.
21. Place the 8 jack nuts and make sure that
the 2 nuts in the bottom are centered with
the silkscreen in the panel.
22. Now you can solder all the
potentiometers and jack sockets.
23. Join the front PCB and the back PCB
using the pin headers and ensuring the 3mm
hole match the spacer. Screw both boards
with the last M3 black screw.