Programming Coffee Dose; Daily Cleaning And Care; External Cleaning - Quality Espresso GAGGIA G6 + Operating Instructions Manual

Please note:

Before programming the different coffee doses, ensure that the grinding point and the doses coffee from the dispenser are
correct. Also, check that the pump is correctly adjusted to 9 bars with only one group making coffee.
To check the pressure of the pump, go to the "Temperatures and pressures" screen (refer to page 30 - fig. C) and if
necessary adjust correctly. The pump is located inside the machine, on the left - to access it, first remove the left side
panel of the machine.
3.3 Programming the coffee dose
1. Enter into the programming mode
2. Programme the dose
3. Exit from the programming mode
1. Enter into the programming mode
1.1. Switch the machine off by means of the general switch.
1.2. Turn the machine on at the general switch and wait for the "VISACREM V6 +" or "GAGGIA G6 +" light located on the
right of the front panel to turn off (refer to figure 1).
1.3. Immediately press and maintain pressed the continuous coffee button of the left group. Maintain the button pressed
until the "VISACREM V6 +" or "GAGGIA G6 +" light comes on. At the top of the screen, the message "PROGRAM
MODE" will appear.
2. Programme the dose
2.1. Press and maintain pressed the button of the product we wish to programme until coffee preparation starts.
2.2. When you have obtained the desired dose, press the same button again to stop the coffee preparation.
2.3. Repeat points 2.1 and 2.2 for all programmable buttons on the left group.
Note: By programming only the left group, the remaining groups will automatically be programmed upon exiting the
programming mode. If in for any other group you wish to obtain a different dose to that programmed on the left group,
continue programming by repeating points 2.1, 2.2 and 2.3, on the groups for which you want to have different doses. Then
exit the programming mode – see step 3 below.
3. Exit from the programming mode
3.1. Turn the machine off and back on at the general switch.
4.

Daily cleaning and care

 The machine must be cleaned on a daily basis in order to guarantee the necessary hygiene and the quality of the end product, as
well as a long working life for the machine.

4.1 External cleaning

- Do not use any chemical or abrasive products for cleaning the machine; only use a damp cloth with water. Pay special
attention to the buttons and the areas related to the product preparation: the steam lance, hot water outlet, groups and
filter-holder.
Figure. 1
31