Quality Espresso GAGGIA G6 + Operating Instructions Manual page 36

6. Alarm, warning and function messages.
MESSAGES
W16-DOSE TOO LARGE GROUP 3
W17-DOSE TOO LARGE GROUP 4
E19- *** ALARM ***
E22-BOILER HEATING ERROR
E23-LEFT STEAM ARM
E23-RIGHT STEAM ARM
W28-PREVENTIVE MAINTENANCE
W29-CHECK GRINDER
W31-STEAM NOT AVAILABLE
E32-PUSHBUTTON ERROR
E51-¡PARAMETER ERROR!
PRESSURE COMPENSATION
BOILER EMPTYING
PROGRAM MODE
GROUP CLEAN CYCLE START
GROUP CLEAN CYCLE FINISHED
ACTIONS TO BE TAKEN
Dose programmed on group 3 is too large, exceeding the maximum number of
impulses.
Dose programmed on group 4 is too large, exceeding the maximum number of
impulses.
Call the technical service. Error in the internal configuration of the control unit.
When this alarm appears, the machine will operate using the default factory
parameters for boiler pressure, coffee doses, etc.
Ensure that the general switch is in position "1" or "
the model). If it is in this position, call the technical service.
The left steam arm is not detected. Also indicated by means of the left steam button
flashing. Call the technical service.
The right steam arm is not detected. Also indicated by means of the right steam
button flashing. Call the technical service.
Call the technical service. Refer to page 40 - "Parameter 5/7" screen
Call the technical service. Refer to page 40 - "Parameter 5/7" screen
Indicates that the temperature of the steam boiler is below 103ºC. Wait
until the temperature reaches the programmed temperature.
Call the technical service.
Call the technical service. Error in the internal configuration of the Display. When
this alarm appears, the Display selects the default "language" and "password"
(SPANISH, 1234)
Wait until the message disappears. This cycle is activated when starting the
machine, provided the temperature inside the boiler is below 60ºC.
By keeping the hot water button pressed down for 3 seconds, the partial emptying
of the boiler is activated. This is indicated by the hot water button flashing and the
message "BOILER EMPTYING" appearing on the Display.
Indicates that the machine is in programming mode.
Indicates that the machine is performing the automatic cleaning cycle.
Indicates that the machine has finished the automatic cleaning cycle.
35
" (cup-warmer depending on