Dose Programming; Cleaning And Daily Care; External Cleaning - Quality Espresso Ruby2 User Manual

3.3 Dose Programming

• We can program the amount of coffee one the one-coffee and two-coffee pushbuttons.
Enter Program mode:
1
•
With the machine turned off, hold down the continuous coffee button. Turn on the machine and wait 4 seconds with the
continuous coffee key pressed until the selection button lights turn off. Only the one-coffee and two coffee buttons are
programmable.
Programming the Amount
2
a. Put the ground coffee or the capsule (according
to the model) in the filter holder for one or two
coffees and insert into the group head.
b. Press the one-coffee key of the left group for
more than 3 seconds until the coffee begins to
come out. When you have reached the desired
amount of coffee, press the same key again.
Repeat these steps on the two-coffee key.
c. To exit programming mode you must turn off
and turn on the machine again with the main
power switch. Doses of the first group are
copied to the second group.

Cleaning and Daily Care

4.
•
Keep the machine in optimal conditions of cleanliness is a daily requirement for guaranteeing the necessary higiene and good
Quality of the final beverage, as well as a longer service life for the machine.

4.1 External Cleaning

Do not use any chemical or abrasive products
to clean the machine. Only use a cotton cloth
moistened with water. Pay special attention to
the pushbuttons and the areas related to
beverage preparation: the steam arm, the hot
water outlet and the filter holder and group
head.
4.3 Daily care
At the beginning of the day
1. Activate the group head for 20 seconds to urge the water
in the circuit.
2. Check that the water comes out through the shower in a
single, continuous stream. If it does not, clean it with the
blind filter. Replace the part and spout if the problem
persists.
3. Remove from the grinder dispense chamber any ground
coffee from the previous day.
4. Verify that the ground coffee dose and grinding point are
correct.
5. Prepare a coffee and verify that it comes out correctly.
Practical Advice
i
- Do not stack cups more than three cups high.
- Avoid reheating milk. Heat in small amounts.
- Before foaming milk, open the steam valve to purge it. Once the foaming is done, purge again and clean the tube with a
damp cloth.
Flowmeter alarm
If we are programming the amount of coffee for one
i
coffee and two coffees and more than 15 seconds go by
without detecting counter impulses, the flowmeter
warning will be activate and the one-coffee and two-
coffee keys will begin to blink. To turn off the blinking,
press any key, which will return you to programming
mode. If after trying again the warning signal appears,
call a service technician.
4.2 Group Head Rinsing
Rinse the group head daily to maintain an optimal quality of coffee. To
clean the coffee holder, follow these instructions.
1. Put the blind filter in the filter holder.
2. Insert the filter holder into the part.
3. Press the continuous coffee key and wait 10 seconds.
4. Press the continuous key again to stop and wait 10 seconds.
Repeat this cleaning cycle 15 times, until the water comes out
clean thorough the discharge valve.
1. Limitar la cantidad de café a moler, al consumo del
momento, ya que el café que queda molido de un día
1. Limit the amount of coffee to be ground to single
servings since the ground coffee from one day should be
discarded the next.
2. Rinse the group head with the help of the blind filte.
3. Clean the filter and the filter holder with hot water and
hold it up to the light to make sure the filter holes are not
obstructed. Leave the filter holder in the group head
without over-tightening it.
4. Clean the steam arm with a damp cloth and purge it
several times.
5. Clean the drainage tray.
At the end of the day
7