Würth 0772 800 Operating Instructions Manual page 16

CRANKING VOLTS
××.×× V NORMAL
CRANKING VOLTS
××.×× V LOW
CRANKING VOLTS
NO DETECTED
PRESS ENTER FOR
CHARGING TEST
MAKE SURE ALL
LOADS ARE OFF
ALT. IDLE VOLTS
××.××V LOW
ALT. IDLE VOLTS
××.××V NORMAL
ALT. IDLE VOLTS
××.××V HIGH
TURN ON LOADS
AND PRESS ENTER
16
Cranking volts normal
The system is showing a normal result. Press ENTER to perform the charging
system test.
Cranking volts low
The start voltage is below the normal values. Look for errors as recommended by
the manufacturer.
Crancking volt no detected
The cranking voltage has not been detected.
If the cranking voltage is normal, press Enter to begin charging system test.
If you press Enter the adjacent screen appears.
Press the Enter key and one of the three results will be displayed along with the
relevant reading.
Low charging volts when test at idle
The alternator is not providing sufficient current to the battery.
Check the v-belts to ensure the alternator is rotating with engine running. If the
belts are slipping or broken, replace the belts and test again. Check the con-
nections from the alternator to the battery. If the connection is loose or heavily
corroded, clean or replace the cable and retest. If the belts and connections are
in good working condition, replace the alternator.
Charging system normal (test without loads)
The system is showing normal output from the alternator. No problem detected.
Charging voltage high (test without loads)
The voltage output from the alternator to the battery exceeds the normal limits
of a functioning regulator. Check to ensure there is no loose connection and
the ground connection is correct. If there are no connection issues, replace the
regulator of the alternator. Since most alternators have the regulator built-in, this
will require you to replace the alternator. The normal upper limit of a typical auto-
motive regulator is 14.7 volts +/- 0.05. Check manufacturer specifications for the
correct limit, as it will vary by vehicle type and manufacturer.
Following the charging system at idle, press Enter for the charging system with
accessory loads. Turn on the blower to high (heat), highbeam headlights, and
rear defogger. Do not use cyclical loads such as air conditioning or windshield
wipers.