Fixing The Rear Operator Mounting; Temporary Installation Of The Operator - Aprimatic ZT4 C Manual

4.2

FIXING THE REAR OPERATOR MOUNTING

Position the rear mounting (B4 pos. 4) at the height previously
measured and weld it on the anchorage plate with two weld points
(C9).
Check the lengthwise and crosswise alignment of the mounting
(C10) with a water level.
Complete the welding and clean away the residues with a wire
brush.
!
Warning
• Before welding, ensure that there are no bushes (B4 pos. 5)
in the mounting, and that the fi tting hole is properly protected
from weld residues.
• When the welded zone has cooled down, apply a coat of
anti-rust paint.
4.3 TEMPORARY INSTALLATION OF THE
OPERATOR
Temporarily mount the operator to fi nd the correct fi xing position
of the front mounting.
!
Warning
Handle the operator with care during assembly.
Fit the fork (C11 pos. 1) to the operator bottom. Lock the fork with
the special pin (C11 pos. 2) and fi x both with the two snap rings
(C11 pos. 3).
Fit the two vibration damping bushes (C12 pos. 4) above and below
the mounting.
Position the fork of the operator on to the mounting and lock it with the
vertical pin (C13 pos. 5) after greasing abundantly.
!
Warning
Grease both the pin and the housings abundantly.
C9
C11
1
3
C12
- 21 -
Installation
2
3
C10
C13