Sideburner Maintenance; Rotisserie Troubleshooting - Weber SUMMIT S-670 Owner's Manual

SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in
the "OFF" position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
2) Ground wire
3) Burner
Side Burner Ring & Head
PROBLEM
Rotisserie burner does not light.
General Symptoms:
Burner does not light. -or- Burner has
a small flickering flame
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
WWW.WEBER.COM
®

SIDEBURNER MAINTENANCE

Side Burner Grate
Side Burner cap
Igniter Electrode
Control Knob
Igniter

ROTISSERIE TROUBLESHOOTING

CHECK
Did you hold the burner control knob in and
hold in for 20 seconds until after burner
ignited?
Did you wait to see the entire ceramic surface
become alight before counting 20 seconds?
Did you repeatedly use the snap ignition until
the burner ignited?
Does the igniter work (Do you see a spark
when you repeatedly use the snap igniter?
The excess flow safety device, which is part of
the barbecue to cylinder connection, may have
activated.
® .
Try to relight burner by holding burner control knob in and continue holding in until
20 seconds after burner has ignited.
When relighting burner by holding burner control knob in, wait to see the entire
ceramic surface become alight before counting 20 seconds?
After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
the burner ignites (refer to "Lighting the Rotisserie Burner").
Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
customer service.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve to "OFF". Disconnect the regulator from the cylinder. Turn burner control
knobs to "START/HI". Wait at least 1 minute. Turn burner control knobs to "OFF".
Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to
"Lighting Instructions".
27
CURE
27