DeLonghi ELETTA CAPPUCCINO EVO ECAM46.86X Instructions For Use Manual page 19

DISPLAYED MESSAGE
Fill beans container
ESC to cancel
Ground too fine
Adjust mill
ESC to cancel
Less coffee
ESC to cancel
Insert water spout
Insert milk container
Insert infuser assembly
Water circuit empty
Fill water circuit
Hot water
Confirm?
Press OK to CLEAN
Set dial to CLEAN
ESC to cancel
Turn froth adjustment dial
Descale
ESC to cancel
OK to descale
(∼45 minutes)
POSSIBLE CAUSE
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted or is
inserted incorrectly.
The milk container (D) is not inserted correctly. Insert the milk container (fig. 16) as far as it
The infuser has not been replaced after
cleaning.
The water circuit is empty.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
The machine must be descaled.
REMEDY
Fill the beans container (A4) (fig. 8).
Empty the funnel with the help of the brush
(C5) as described in section "11.8 Cleaning the
pre-ground coffee funnel".
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 11) one click clockwise
towards "7" while the coffee mill is in operation.
If after making at least 2 coffees delivery is still
too slow, repeat the correction procedure, turn-
ing the grinding adjustment dial another click
(see section "7.4 Adjusting the coffee mill"). If
the problem persists, make sure the water tank
(A14) is fully inserted.
Insert the hot water spout (C) in the appliance
and deliver a little water until the flow be-
comes regular.
Select a lighter taste by pressing
or reduce the quantity of pre-ground coffee.
Fully insert the hot water spout (fig. 5).
will go.
Insert the infuser as described in section "11.9
Cleaning the infuser".
Press
spout (C6). If the problem persists, make sure
the water tank (A14) is fully inserted.
To proceed with the CLEAN function press
(B11) or turn the froth adjustment dial
to another position.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 20).
Turn the froth adjustment dial to one of the
milk froth positions.
The descaling procedure described in section
"12. Descale" needs to be performed.
19
(B11) and deliver water from the
(B11)
→