Disposal And Recycling; Troubleshooting - Scheppach HC25o Translation Of Original Instruction Manual

10.5 Releasing excess pressure
Release the excess pressure by switching off the
compressor and using the compressed air which
is still left in the pressure vessel, e.g. with a com-
pressed air tool running in idle mode or with a blow-
out pistol.

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE).

12. Troubleshooting

Fault Possible cause
• No supply voltage.
• Insufficient supply voltage.
The compressor does
not start.
• Outside temperature is too low.
• Motor is overheated.
• The non-return valve leaks.
The compressor starts
• The seals are damaged.
but there is no pres-
sure.
• The drain plug for condensation water
(9) leaks.
• The hose connections have a leak.
The compressor
starts, pressure is
• A quick-lock coupling has a leak.
shown on the pressure
gauge, but the tools
• Insufficient pressure set on the pres-
do not start.
sure regulator (3).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
This product must be disposed of at a designated col-
lection point. This can occur, for example, by handing
it in at an authorised collecting point for the recycling
of waste electrical and electronic equipment. Improp-
er handling of waste equipment may have negative
consequences for the environment and human health
due to potentially hazardous substances that are of-
ten contained in electrical and electronic equipment.
By properly disposing of this product, you are also
contributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedy
• Check the supply voltage, the power plug and
the socket-outlet.
• Make sure that the extension cable is not too
long. Use an extension cable with large enough
wires.
• Never operate with an outside temperature of
below +5° C.
• Allow the motor to cool down. If necessary, rem-
edy the cause of the overheating.
• Have a service center replace the non-return
valve.
• Check the seals and have any damaged seals
replaced by a service center.
• Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
• Check the compressed air hose and tools and
replace if necessary.
• Check the quick-lock coupling and replace if
necessary.
• Increase the set pressure with the pressure
regulator.
GB | 21