EUFAB 16616 Manual page 9

Motorbike winter mode
Charging programme for 12 V batteries from 1.2 Ah to 14 Ah, temperatures
below 0°C
Charge current: 2 A maximum
charge voltage: 14.8 V
Car mode
Charging programme for 12 V batteries from 14 Ah to 120 Ah, temperatures
above 0°C
Charge current: 4 A maximum
charge voltage: 14.6 V
Car winter mode
Charging programme for 12V batteries from 14 Ah to 120 Ah, temperatures
below 0°C
Charge current: 4 A maximum
charge voltage: 14.8 V
Battery maintenance charge mode
As soon as the battery is fully charged, the charger switches automatically over
to battery maintenance charge mode. This is indicated appropriately on the
display.
Error messages
Error message
Display of error after faulty connection (wrong poles), short-circuit, selection of
Display of error after fault connection (wrong poles), short-circuit, selection of
an incorrect charging programme or overheating.
an incorrect charging programme or overheating.
Error message in 6 V – mode, if a battery is connected with less than 5.5 V ±
0.2 or the voltage is still lower than 6 V after 6 hours of charging time.
Removing the charger
Caution: First pull the plug out of the socket and observe the sequence for disconnection. This prevents
sparks from forming. Since charging generates a detonating gas, this is particularly important for the sake
of your safety.
Disconnect the charger from the mains power supply.
Then disconnect the black callipers (minus). Then remove the battery callipers from the plus pole of the battery
(red callipers).
Allow the battery to cool and fill the cells with distilled water to the filling level named by the battery manufactu-
rer. Close the battery cells using the caps.
Maintenance and care
Maintenance: If used correctly, the device is maintenance-free.
Care: Clean the pole callipers every time the charging procedure is completed. Remove all splashed battery acid
from the pole callipers to prevent corrosion. Clean the device carefully with a dry cloth. Do not use liquids or chemi-
cal cleaning agents. Never submerge the device in liquids. Never allow liquid to flow over the device.
Before storing the device, roll up the cables properly using the designated hook in order to prevent damages to the
cables and device. Store the device in a clean and dry place.
Notes regarding environmental protection
The packaging is made up of environmentally friendly materials which may be disposed of via your local
recycling points.
Do not put electrical devices into the household waste. Electronic and electrical devices must be
collected separately and sent for environmentally friendly recycling. Contact your community or town
administration for information regarding the disposal of electrics.
9