EUFAB 16616 Manual page 7

on the type plate of the device.
Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit
cannot be replaced. In the event that the cable is damaged, the unit must be disposed of.
Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective. In this
case, contact our technicians.
Pull the plug when the device is not in use.
Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation!
Remove all plastic from the device before use.
Lay the mains cable in such a way that you are not hindered by it, and no one is able to accidentally pull it.
Disconnect the battery charger from the power supply after charging.
Keep the charger in a place that cannot be accessed by children or unauthorised persons.
Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive! Immedia-
tely and thoroughly wash off any splashed acid and consult a doctor if necessary. If battery acid gets into
the eyes, immediately rinse under running water for at least 10 minutes and consult a doctor.
Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the parking
brake and switch off the ignition. Cut the battery off from the on-board network of your vehicle. To do this, consult
the manual for your vehicle, or ask your specialist workshop.
When pulling the mains cable out of the socket, only hold the plug.
Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
Store these instructions carefully and, if necessary, pass them on to other users.
Operating instructions
Figure 1: Overview
1. Battery voltage display
2. 6 V charging programme
3. Winter charging programme
4. 12 V charging programme
5. Car charging programme
6. Motorbike charging programme
7. Battery charge status display
Preparation
Clean the battery pole of dust and corrosion residue. Only for open batteries: Top up with distilled water until the
minimum filling level is reached. Leave the cells of the battery open until the end of the charging process. With
A MODE button
B Display
C Charging cable
D Pole callipers, red (+)
E Pole callipers, black (-)
F Mains cable
G Hook for rolling up the cable
Figure 2: Display
7