Safety Information - Watts PVI Aqua Solve Family Installation Manual

The installation must conform to them.
Do not locate the softener where freezing temperatures occur. Do not
attempt to treat water over 49ºC. Freezing or hot water damage will
void your warranty.
IMPORTANT: INSTALLATION AND
Avoid installing in direct sunlight. Excessive sun heat may cause
distortion or other damage to non-metallic parts.

SAFETY INFORMATION

Maximum allowable inlet water pressure is 4.76 bar.
If the daytime pressure exceeds 4.76 bar, a pressure reducing valve is
recommended (adding a pressure reducing valve may reduce the flow).
Follow the installation instructions carefully. Failure to install the
The softener works on 24 volt 50 Hz electrical power only. Be sure to
softener properly may void the warranty.
use the supplied transformer and plug it into a normal 240V, 50Hz
household outlet that is in a dry location only, grounded and prop-erly
Use care when handling the softener. Do not turn upside down, drop, or
protected by an over current device such as a circuit breaker or fuse.
set on sharp protrusions.
Before you begin installation, read this entire manual. Then obtain all the This softener is not intended to be used for treating water that is
microbiologically unsafe or of unknown quality without adequate
materials and tools you will need to make the installation.
disinfection before or after the system.
Check local plumbing and electrical regulations and byelaws.
The installation must conform to them.
Do not locate the softener where freezing temperatures occur. Do not
attempt to treat water over 49ºC. Freezing or hot water damage
will void your warranty.
Avoid installing in direct sunlight. Excessive sun heat may cause
distortion or other damage to non-metallic parts.
Maximum allowable inlet water pressure is 4.76 bar.
If the daytime pressure exceeds 4.76 bar, a pressure reducing valve is
recommended (adding a pressure reducing valve may reduce the flow).
The softener works on 24 volt 50 Hz electrical power only. Be sure
to use the supplied transformer and plug it into a normal 240V, 50Hz
household outlet that is in a dry location only, grounded and properly
protected by an over current device such as a circuit breaker or fuse.
This softener is not intended to be used for treating water that is
microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Please Remember – Only use tablet or pellet salt in your softener!
4
4
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
LEAD PIPEWORK
• Consult the dealer or an experienced radio/TV technician for help.
Where lead pipework exists downstream of the proposed location of the
Changes or modifications not expressly approved by EcoWater Systems
water softener, we advise you ask the local water authority for advice
could void the user's authority to operate the equipment.
on the replacement of lead pipework.
European Directive 2002/96/EC requires all electrical and
electronic equipment to be disposed of according to Waste
European Directive 2002/96/EC requires all electrical and
Electrical and Electronic Equipment (WEEE RM05711)
electronic equipment to be disposed of according to Waste
requirements.
Electrical and Electronic Equipment (WEEE
requirements.
RM05711)