Maintenance - Bissell REVOLUTION PROHEAT 2X 1858 Instructions Manual

Maintenance: Cleaning the Brush Rolls
1
Turn off and unplug
the machine from the
grounded outlet.

Maintenance:

You will need: 1 Phillips screwdriver & 1 flathead screwdriver
1
Unplug the machine. Remove both tanks
from the machine. Press the recline pedal
and lay the machine on its back. Use
a flathead screwdriver to help lift and
remove the Belt Access Door.
2
Here you should see one (1) belt.
This is the Flat Pump Belt. If the
Flat Pump Belt is broken, gently
remove it from the machine. We
will replace this belt in Step 5.
4
Remove the Brush Cover by lifting
straight up. Remove the Cogged
Large Pump Belt. The brush rolls can
be replaced or cleaned at this time, if
needed.
Now, if the Flat Pump Belt
5
was broken, place a new
Flat Pump Belt around the
red area of the large pulley.
Then use your thumb to
stretch it toward the back
of the machine and transfer
it onto the metal axle.
2
Lay the machine down
on its back or side.
Replacing Belt or Brush Rolls
3
Turn the machine on its side. The Power Button
should be facing up. Remove the 3 screws on
the Belt/Brush Access Plate using a Philips
screwdriver. Remove the Access Plate to expose
the Brush Cover and Cogged Large Pump Belt.
3
Use the comb
to brush out the
debris or hair from
the brush rolls.
www.BISSELL.com
13