Bissell REVOLUTION PROHEAT 2X 1858 Instructions Manual page 14

Replacing Belt or Brush Rolls (continued)
6
7
To replace the Cogged Large Pump Belt, make
sure your Revolution is completely reclined.
Begin by wrapping the Cogged Large Pump
Belt around the small metal-toothed pulley.
While wrapped around the pulley, stretch and
wrap around the nearest brush gear.
8
Return the Brush Cover.
Make sure that the brushes
are aligned and the cover
is secure.
Maintenance: Removing Handle for Storage
You will need: 1 Phillips screwdriver & 1 flathead screwdriver
1
3
14
www.BISSELL.com
Spin either brush. If they both spin, continue to Step 7.
If only one spins, the opposite belt is broken and you must
remove both brushes and replace the Small Cogged Brush Belt.
Place the new belt around both brush gears and slide them onto
the thin metal axles.
9
Return the Belt/Brush
Access Plate to the
end of the brush rolls
by securing with the 3
screws.
Unplug the
machine. Remove
the screw in the
back of the unit
on the carry
handle using
a Phillips head
screwdriver.
Remove top water
tank and carefully
use the flathead
screwdriver to pry up
the grey plastic tab
on the plastic base of
handle. While you pry
this forward the metal
handle can easily slide
up and out.
10
Turn the machine to lay on
its back. Then slide the Belt
Access Door back into place.
You should hear it "click"
into place.
2
4
Gently pry the
carry handle
off using your
thumb and pulling
outward at the
side, not the back.
Repeat both sides.
Lastly you remove
the base of the
handle by hand,
it should pop off
easily and can be
slid back on the
handle.